High Frequency Tesla Coil Electronic Candle Plasma Flame Electronic Candle Technology Toys DIY Handmade

Product information:

Name: Hfsstc (high frequency Tesla coil) commonly known as “electronic candle”

Working voltage: DC36V-48V

Working current: 1.8-2.5A

Working frequency: around 15mhz

Size:145x85x105mm(without power)/230x130x80mm(with power)

Safety precautions:

Please use strictly in accordance with the instructions, if improper use is likely to cause fire, electric shock, burns and other accidents

Parts that are strictly forbidden to touch during work: the secondary coil, the top coil of the main unit, and the output discharge needle of the main unit

Do not use over-voltage, the working power supply voltage should not be higher than DC 52V

Don’t change the parameters arbitrarily

The positive and negative poles of the power supply are strictly prohibited

The recommended working time is less than 10 minutes. Exceeding the time will cause high temperature aging and damage to the ignition coil

To ensure safety, please make sure that there are no flammable and explosive materials around the product before work

When working, it will produce certain electromagnetic interference to the surrounding electronic equipment

This product is not waterproof, please do not use it in an excessively humid place

Do not use objects to connect the high temperature tape part of the primary secondary coil during work to avoid secondary damage

Use steps/methods:

1. Place the host and connect the host and secondary coil correctly

2. Connect the power supply and the fan starts to work

3. Turn on the switch, and the indicator light next to the switch is on (the left side of the switch is on and the right is off) the indicator light on the bottom of the coil is on

4. Touch the top of the secondary coil with metal as soon as possible to ignite the flame

Note: If the power indicator is on but not working after turning on the switch, you need to adjust the potentiometer on the host

Adjustment method: After turning on the switch, slowly rotate clockwise until the signal light on the top of the main engine lights up, and the secondary ignition coil can be ignited. Adjusting to just the arc is the best state, too large will cause the main circuit current to be too large or even damage! (All have been debugged before shipment, use this method to adjust under special circumstances)